For several years, since I first started working on my Boba Fett costume, I’ve thought it would be fun to build a costume that would be worthy of joining the 501st. If you’re not familiar with the 501st, it’s a international volunteer Star Wars costuming organization. It’s the organization that provides characters to zoos, events, hospital visits to sick kids, and even the characters at Disney’s Star Wars Weekends.
The only problem is that the 501st are very picky about costume details, and I knew that I would have to spend several hundred dollars to finish out my Boba Fett costume. Instead, I decided to sell off the parts and use the money I made to build a new costume. The character I picked was the Sith Acolyte Eradictor from one of the Star Wars video games (that I’ve never played).
Basically, I wanted to carry a lightsaber and wear a mask. And this guy looks awesome. In fact, I think he might be able to take Boba.
Well, after many hours of work, I’ve finally completed my costume, and this afternoon we did a little photo shoot. This evening I submitted my application for the 501st. :)
I made everything except for the mask and the lightsaber. Below, I’ve posted a bunch of photos that I took during the build. As you hover over these images, you should see some notes related to each.
[update 11/2/15: My costume didn’t get 501st approval. Plan on working on an updated set of armor over the next few months.]
I started by cutting out the chest piece from 1/2″ foam.
Adding details with a Dremel tool
Using a heat gun to shape the piece and seal the foam a bit.
Painting the armor with black plasti-dip to finish the seal on the foam.
Looking good!
Cutting the thigh armor.
Thigh armor detailed out
Armor has been fitted to my legs and connected on the back side.
Preparing the elbow armor.
I used a second piece of foam glued to the back to give these pieces some dimension.
Cutting out the robe fabric.
Cutting the hood material.
Beginning work on the top half of the gauntlets.
Using the heat gun to shape the piece and tape to hold the shape.
Adding details to the gauntlets – thin craft foam is perfect for this.
Upper gauntlets sprayed with plasti-dip
Working on the hand armor.
So happy with the way these turned out. Once they’re painted, they look vicious!
Trying things on.
Trying out the silver Rub n’ Buff
So rad.
Working on the harness for the chest piece.
Cutting the belt buckle.
Cutting out the pouches.
Making bottom halves for the gauntlets.
Connecting up the gauntlets.
Gluing all the foam details to my tactical gloves.
After some work, I decided to connect an abdomen/codpiece component directly to the chest piece.
Finished gauntlets.
After a test fit, I determined that my chest piece was too wide and too tall. Here are the pieces that I cut off.
Building pauldrons for my shoulders.
Without a doubt, the hardest part of the costume were the lower leg pieces.
After a couple of failed attempts, I decided to go with a solid piece that would open up with a zipper.
Wish that I had installed this zipper higher on the leg or the zipper was longer. It’s very difficult to get these on, but they work. :)
Adding details to the leg pieces
Additional parts for the lower legs.
Adding Rub n’ Buff
Finished legs! Finally!
Rough cutting some three-layered foam for the belt canister.
Got a tip to use cheap concrete boots. Ended up cutting off the uppers and leaving them like a slip-on shoe.
Covering the shoe with craft foam.
Adding details.
Using fabric paint to paint the sleeves.
Thanks for checking things out! Hopefully I get some good news on my costume approval soon!
If you’re interested in seeing more things like this that I’ve built, check out the category here.
And here’s all the parts bagged up into two large suitcases for the photo shoot: